Document Center is acquired by Nimonik

Scope

1.1 This test method describes procedures to establish the relative bond strength of steel reinforcing bars in concrete.

1.2 This test method is intended to determine the effects of surface preparation or condition (such as bar coatings) on the bond strength of deformed steel reinforcing bars (of sizes ranging from No. 10 to No. 35 [No. 3 to No. 11]) to concrete.

1.3 The values stated in SI units are to be regarded as the standard. The values given in brackets are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Austenitic steel pipe; Seamless steel pipe; Spray-formed steel pipe; Steel pipe-austenitic alloy; spray-formed seamless austenitic stainless steel pipes; ICS Number Code 91.080.10 (Metal structures)

To find similar documents by ASTM Volume:

01.04 (Steel--Structural, Reinforcing, Pressure Vessel, Railway)

To find similar documents by classification:

91.080.10 (Metal structures)

91.080.13 (Steel structures)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.