ASTM-A862 › Standard Practice for Application of Asphalt Coatings to Corrugated Steel Sewer and Drainage Pipe
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers the post coating of corrugated steel pipe and corrugated structural steel plate with asphalt materials. This practice is intended for shop-applied coating only.
1.2 The values stated in either inch-pound units or SI units shall be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, use each system independently of the other, without combining values in any way. The SI units are shown in brackets in the text for clarity, but they are the applicable values when the application is to be performed using SI units.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
3.1 Asphalt coating is used to provide additional protection for corrugated steel products (product) in corrosive or abrasive environments, or both.
Keywords
asphalt coated steel pipe; asphalt coating; asphalt coating repair; coating application; corrugated steel pipe; paved invert; protective coatings; smooth lined
To find similar documents by ASTM Volume:
To find similar documents by classification:
23.040.50 (Pipes and fittings of other materials)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A862/A862M-98(2014)
Revision Level
1998 R14 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
May 15, 2014
Document Type
Practice
Page Count
2 pages
Committee Number
A05.17