ASTM-A622 › Standard Specification for Drawing Steel (DS), Sheet and Strip, Carbon, Hot-Rolled (Withdrawn 2000)

ASTM-A622 - 1997 EDITION - SUPERSEDED -- See the following: ASTM-A1011
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Specification for Drawing Steel (DS), Sheet and Strip, Carbon, Hot-Rolled (Withdrawn 2000)

ORDER

Want this as a site license?

Scope

1.1 This specification covers hot-rolled carbon steel sheet and strip of drawing quality, special killed, in coils or cut lengths. This material is intended for use in fabricating identified parts where particularly severe drawing or forming may be involved and surface appearance is usually not of primary importance.

1.2 This specification is applicable for orders in either inch-pound units (as A 622) of SI units (as A 622M).

Keywords

Carbon steel sheet; carbon steel strip; hot rolled steel sheet; hot rolled steel strip; steel sheet; steel strip

This document comes with our free Notification Service, good for the life of the document.

This document is available in Paper format.

Customers who bought this document also bought:

ASTM-A1008
Standard Specification for Steel, Sheet, Cold-Rolled, Carbon, Structural, High-Strength Low-Alloy, High-Strength Low-Alloy with Improved Formability, Solution Hardened, and Bake Hardenable

ASTM-A1011
Standard Specification for Steel, Sheet and Strip, Hot-Rolled, Carbon, Structural, High-Strength Low-Alloy, High-Strength Low-Alloy with Improved Formability, and Ultra-High Strength

ASTM-A108
Standard Specification for Steel Bar, Carbon and Alloy, Cold-Finished

Document Number

ASTM-A622/A622M-97

Revision Level

1997 EDITION

Status

Superseded

Modification Type

Replaced

Publication Date

March 10, 1997

Document Type

Specification

Page Count

2 pages

Committee Number

A01.19

Document Center is acquired by Nimonik