ASTM-A1028 › Standard Specification for Stainless Steel Bars for Compressor and Turbine Airfoils (Withdrawn 2021)
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers stainless steel bars for compressor and turbine bucket, blade, and airfoil applications. Materials shall be produced by basic electric furnace melting process with argon-oxygen-decarburization refining or by vacuum ladle degassing. Electro-slag remelting shall also be conducted unless otherwise specified by the purchaser. Two complete heat treatments, consisting of an austenize, quench, and temper, shall be conducted. Straightening, stress relieving, and water or oil quenching shall be executed as well. Steel bars shall adhere to chemical composition and mechanical property requirements, including tensile strength, yield strength, elongation, reduction of area, impact strength, and Brinell hardness.
Scope
1.1 This specification covers stainless steel bars for compressor and turbine bucket, blade, and airfoil applications.
1.2 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.
Keywords
compressor airfoils; martensitic stainless steel; stainless steel bar; turbine airfoils;
To find similar documents by ASTM Volume:
01.03 (Steel--Plate, Sheet, Strip, Wire; Stainless Steel Bar)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A1028-03(2015)
Revision Level
2003 R15 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
March 1, 2015
Document Type
Specification
Page Count
4 pages
Committee Number
A01.17