SS-ISO-7129 › Earth-moving machinery - Cutting edges used on tractor-dozers, graders and scrapers - Principal shapes and basic dimensions (ISO 7129:1997, IDT)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This International Standard specifies the principal shapes and dimensions of the cross-section, the hole location for the mounting bolts, the shapes and dimensions of holes for the mounting bolts, for cutting used on tractor-dozers, graders and scrapers, as defined in ISO 6165, taking interchangeability intoconsideration. NOTE Some values in inches in this International Standard are not equivalent to the corresponding values in millimetresbecause widely used values have been adopted.
To find similar documents by classification:
53.100 (Earth-moving machinery Including tractors, excavators, loaders, graders, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 7129:2007
Revision Level
2007 EDITION
Status
Current
Publication Date
Oct. 22, 2007
Language(s)
English
Page Count
24
International Equivalent
ISO 7129:1997(IDT)