SS-ISO-3019-1 › Hydraulic fluid power - Dimensions and identification code for mounting flanges and shaft ends of displacement pumps and motors - Part 1: Inch series shown in metric units
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 3019 specifies sizes and dimensions and establishes an identification code for the two- and four-bolt mounting flanges and the shaft ends of positive-displacement, rotary hydraulic fluid power pumps and motors. It is applicable to cylindrical keyed shaft ends with an external thread, as well as to those without a thread, to conical keyed shaft ends with an external thread and to 30° involute spline shaft ends. NOTE Involute spline is in accordance with SAE J744 [1] .
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 3019-1
Revision Level
EDITION 1
Status
Superseded
Publication Date
Sept. 14, 2001
Language(s)
English, Swedish
Page Count
15
International Equivalent
ISO 3019-1:2001(IDT)