SS-ISO-2919 Radiological protection - Sealed radioactive sources - General requirements and classification (ISO 2919:2012, IDT)

SS-ISO-2919 - 2012 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This International Standard establishes a classifcation system for sealed radioactive sources that is based on test performance and specifes general requirements, performance tests, production tests, marking and certifcation. It provides a set of tests by which manufacturers of sealed radioactive sources can evaluate the safety of their products in use and users of such sources can select types which are suitable for the required application, especially where protection against the release of radioactive material, with consequent exposure to ionizing radiation, is concerned. This International Standard can also serve as guidance to regulating authorities.The tests fall into several groups, including, for example, exposure to abnormally high and low temperatures and a variety of mechanical tests. Each test can be applied in several degrees of severity. The criterion of pass or fail depends on leakage of the contents of the sealed radioactive source.NOTE Leakage test methods are given in ISO 9978.Although this International Standard classifes sealed sources by a variety of tests, it does not imply that a sealed source will maintain its integrity if used continuously at the rated classifcation. For example, a sealed source tested for 1 h at 600 °C might, or might not, maintain its integrity if used continuously at 600 °C.A list of the main typical applications of sealed radioactive sources, with a suggested test schedule for each application, is given in Table 3. The tests constitute minimum requirements corresponding to the applications in the broadest sense. Factors to be considered for applications in especially severe conditions are listed in 4.2.

To find similar documents by classification:

13.300 (Protection against dangerous goods Including performance requirements for dangerous goods, their handling, storage, transportation, marking, labelling, etc. Nuclear fissile materials, see 27.120.30 Explosives, see 71.100.30)

27.120.20 (Nuclear power plants. Safety Radiation protection, see 13.280)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.




Designation Name

SS-ISO 2919:2012

Revision Level

2012 EDITION

Status

Superseded

Publication Date

Feb. 22, 2012

Language(s)

English

Page Count

32

International Equivalent

ISO 2919:2012(IDT)