Document Center is acquired by Nimonik

his part of ISO 8503 specifes the optical microscope and describes the procedure for calibrating ISO surface profle comparators conforming to the requirements of ISO 8503-1.This part of ISO 8503 is also applicable to the determination of the surface profle, within the range hy= 20 µm to 200 µm, of essentially planar blast-cleaned steel. The determination can be carried out on a representative section of the blast-cleaned substrate or, if direct observation of the surface is not feasible, on a replica of the surface (see Annex E).NOTE Where appropriate, this procedure can be used for assessing the roughness profle of other abrasive blast-cleaned substrates.An alternative procedure is described in ISO 8503-4.