SS-EN-ISO-12215-8 › Small craft - Hull construction and scantlings - Part 8: Rudders (ISO 12215-8:2009, including Cor 1:2010)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 12215 gives requirements on the scantlings of rudders fitted to small craft with a length of hull, LH, of up to 24 m, measured according to ISO 8666. It applies only to monohulls. This part of ISO 12215 does not give requirements on rudder characteristics required for proper steering capabilities. This part of ISO 12215 only considers pressure loads on the rudder due to craft manoeuvring. Loads on the rudder or its skeg, where fitted, induced by grounding or docking, where relevant, are out of scope and need to be considered separately. NOTE Scantlings derived from this part of ISO 12215 are primarily intended to apply to recreational craft including charter craft.
To find similar documents by classification:
47.020.10 (Hulls and their structure elements)
87.060.10 (Pigments and extenders)
Amendment to Directive 94/25/EC on the approximation of the laws, regulations and administrative provisions of the Member States relating to recreational craft
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN ISO 12215-8:2018
Revision Level
2018 EDITION
Status
Current
Publication Date
Oct. 8, 2018
Language(s)
English
Page Count
60
International Equivalent
EN ISO 12215-8:2018(IDT); ISO 12215-8:2009(IDT)