SS-EN-ISO-11665-3 › Measurement of radioactivity in the environment - Air: radon-222 - Part 3: Spot measurement method of the potential alpha energy concentration of its short-lived decay products (ISO 11665-3:2020)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This document describes spot measurement methods for determining the activity concentration of short-lived radon-222 decay products in the air and for calculating the potential alpha energy concentration. This document gives indications for performing a spot measurement of the potential alpha energy concentration, after sampling at a given place for several minutes, and the conditions of use for the measuring devices. The measurement method described is applicable for a rapid assessment of the potential alpha energy concentration. The result obtained cannot be extrapolated to an annual estimate potential alpha energy concentration of short-lived radon-222 decay products. Thus, this type of measurement is not applicable for the assessment of annual exposure or for determining whether or not to mitigate citizen exposures to radon or radon decay products. This measurement method is applicable to air samples with potential alpha energy concentration greater than 5 nJ/m3. NOTE This document does not address the potential contribution of radon-220 decay products.
To find similar documents by classification:
13.040.01 (Air quality in general)
17.240 (Radiation measurements Including dosimetry Radiation protection, see 13.280)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN ISO 11665-3:2020
Revision Level
2020 EDITION
Status
Current
Publication Date
Feb. 11, 2020
Language(s)
English
Page Count
28
International Equivalent
EN ISO 11665-3:2020(IDT); ISO 11665-3:2020(IDT)