SS-EN-13566-2 › Plastics piping systems for renovation of underground non-pressure drainage and sewerage networks - Part 2: Lining with continuous pipes
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This Part 2 of EN 13566, read in conjunction with Part 1, specifies requirements and test methods for pipes and fittings which are part of plastics piping systems installed as continuous pipes in the renovation of nonpressure drainage and sewerage networks. It covers; -- homogeneous-wall (HW) pipes made of polyethylene (PE) or polypropylene (PP), -- structured-wall (SW) pipes of the corrugated double-wall type of construction as defined in Annex B,, whose structural layer(s) is (are) made of PE or PP, -- jointing of pipe lengths by means of butt fusion (HW) 1) or electrofusion (SW), -- fabricated and injection-moulded fittings made of PE, PP and poly(vinyl chloride) (PVC-U). NOTE The grouting procedure is outside the scope of this standard.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 13566-2:2005
Revision Level
2005 EDITION
Status
Superseded
Publication Date
Dec. 2, 2005
Language(s)
English
Page Count
31