SS-EN-12373-11 › Aluminium and aluminium alloys - Anodizing - Part 11: Measurement of specular reflectance and specular gloss of anodic oxidation coatings at angles of 20º, 45º, 60º or 85º
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This Part of this European Standard specifies methods for the measurement of specular reflectance and specular gloss of flat samples of anodized aluminium using geometries of 20° (method A), 45° (method B), 60° (method C) and 85° (method D), and of specular reflectance by an additional 45° method (method E) employing a narrow acceptance angle. The methods described are intended mainly for use with clear anodized surfaces. They can be used with colour-anodized aluminium, but only with similar colours.
To find similar documents by classification:
25.220.20 (Surface treatment Including anodization, conversion coating, thermal spraying, etc.)
77.120.10 (Aluminium and aluminium alloys)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 12373-11
Revision Level
EDITION 1
Status
Superseded
Publication Date
Dec. 15, 2000
Language(s)
English
Page Count
19
International Equivalent
EN 12373-11:2000 IDT