Document Center is acquired by Nimonik

Scope

This standard, along with ASME Y14.100M, establishes the essential requirements and reference documents applicable to the preparation and revision of engineering drawings and associated lists for or by Departments and Agencies of the Department of Defense. ASME Y14.100M is the preferred requirements document for engineering drawing practices. This standard should only be used in lieu of ASME Y14.100M where the necessity for a DoD design activity is fully justified and Government logistics support is required . See 6.2.2.

Notes

Claudia's Notes:
MIL-STD-100 came to heavily depend on the ASME Y14 series prior to cancellation in December, 2001.
Here's the complete cross-reference included with the cancellation notice:
1) Commercial Drawings became ASME Y14.100, Engineering Drawing Practices
2) DoD Basic Practices (Chapter 100 of MIL-STD-100) became ASME Y14.100 and the following Appendices, as applicable:
   • Appendix B, Non-Commercial Drawing Practices
   • Appendix C, Drawing Titles
   • Appendix D, Numbering, Coding and Identification
   • Appendix E, Markings on Engineering Drawings
3) Types of Engineering Drawings (Chapters 200 of MIL-STD-100) became ASME Y14.24, Types and Applications Of Engineering Drawings
4) Revision of Engineering Drawings (Chapter 600 of MIL-STD-100) became ASME Y14.35M, Revision of Engineering  Drawings and Associated Lists
5) Associated Lists (Chapter 700 of MIL-STD-100) became ASME Y14.34M, Associated Lists

To find similar documents by Federal Supply Class Code:

FSC Standardization Area DRPR (Drawing Practices)