ISO-9090 › Gas tightness of equipment for gas welding and allied processes
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies the maximum external gas leakage rates which are acceptable for equipment used for welding, cutting and allied processes and provides the procedures of measurement.
It applies to individual components which are used in the gas supply to a blowpipe from the connecting point of the hose (outlet of the cylinder valve or connecting point to a gas supply plant). It does not apply to gas supply plant.
NOTE Specific requirements on the test method and conditions/procedure for measurement of the maximum external leakages can be given in individual standards, e.g. ISO 9012 for air-aspirated hand blowpipes. Concerning the method and the conditions to be applied, the individual standard takes precedence over this document. The maximum external leakages according to this document apply.
To find similar documents by classification:
25.160.30 (Welding equipment Including thermal cutting equipment)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
DIN-477-1Gas cylinder valves for cylinder test pressures up to 300 bar - Part 1: Valve inlet and outlet connections
ASTM-A380
Standard Practice for Cleaning, Descaling, and Passivation of Stainless Steel Parts, Equipment, and Systems
BS-2779
Specification for Pipe Threads for Tubes & Fittings Where Pressure-Tight Joints Are Not
Document Number
ISO 9090:2019
Revision Level
2ND EDITION
Status
Current
Publication Date
Oct. 1, 2019
Committee Number
ISO/TC 44/SC 8