ISO-6363-5 › Wrought aluminium and aluminium alloys - Cold-drawn rods/bars, tubes and wires - Part 5: Tolerances on form and dimensions for drawn square and hexagonal bars and wires

ISO-6363-5 - 3RD EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This document specifies the tolerances on form and dimensions of wrought aluminium and aluminium alloy drawn square and hexagonal bars and wires with widths across flats up to and including 100 mm.

For wires, this document does not apply to electrical, welding and aeronautical purposes.

For drawn bars, 4.1 to 4.5 apply, and only 4.1 applies to drawn wires.

ORDER

Price:

$48.00        


Want this as a site license?

To find similar documents by classification:

77.150.10 (Aluminium products)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ISO 6363-5:2022

Revision Level

3RD EDITION

Status

Current

Publication Date

July 1, 2022

Committee Number

ISO/TC 79/SC 6