ISO-3548-3 › Plain bearings - Thin-walled half bearings with or without flange - Part 3: Determination of the peripheral length
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies, according to ISO 12301, the checking of the peripheral length of thin-walled half bearings with or without flange, and describes the necessary checking methods and measuring equipment.
Thin-walled half bearings are flexible and, in the free condition, do not conform to a cylindrical profile. This is one reason the peripheral length of the half bearings can only be measured under a constraining load by use of specialized measuring equipment.
In addition, measuring equipment different from that illustrated in this document can be used, provided the measuring accuracy of the equipment is consistent with the specifications given in Clause 17.
This document does not include the measurement of the parting line taper.
This document applies to thin-walled half bearings, the specifications of which are given in ISO 3548 1.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 3548-3:2023
Revision Level
2ND EDITION
Status
Current
Publication Date
March 1, 2023
Committee Number
ISO/TC 123/SC 5