ISO-3294 › Parallel shank countersinks for angles 60, 90 and 120 degrees inclusive
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 3294:2016 specifies the dimensions of parallel shank countersinks for angles 60°, 90° and 120° inclusive.
It specifies dimensions in metric units only, these being regarded as the only recommended dimensions in the future, for countersinks with cutting diameters in the range 8 mm to 25 mm.
The dimensions apply only to tools made from high-speed steel. However, if the method of production allows, the shanks may be manufactured from a suitable alternative material, such as a carbon steel.
Unless otherwise indicated, the countersinks will be right-hand cutting.
Morse taper shank countersinks are the subject of ISO 3293.
To find similar documents by classification:
25.100.30 (Drills, countersinks, reamers)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 3294:2016
Revision Level
2ND EDITION
Status
Current
Publication Date
Aug. 1, 2016
Committee Number
ISO/TC 29/SC 9