ISO-25780 › Plastics piping systems for pressure and non-pressure water supply, irrigation, drainage or sewerage - Glass-reinforced thermosetting plastics (GRP) systems based on unsaturated polyester (UP) resin - Pipes with flexible joints intended to be installed using jacking techniques
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 25780:2011 specifies the properties of the piping system and its components made from glass-reinforced thermosetting plastics (GRP) based on unsaturated polyester resin (UP) for water supply, irrigation, drainage or sewerage systems with or without pressure.
ISO 25780:2011 is applicable to GRP-UP piping systems, with flexible joints, intended to be installed using jacking techniques. It specifies the characteristics of pipes made from GRP-UP, with or without aggregates or fillers and also specifies the test parameters for the test methods referred to in ISO 25780:2011.
ISO 25780:2011 is applicable to pipes and joints with a size range from DN100 to DN4000 which are intended to be used for the conveyance of water or sewage at temperatures up to 50ยบC, with or without pressure.
ISO 25780:2011 covers requirements to improve the design of the joint and specifies type test performance requirements for the joints as a function of the declared nominal pressure rating of the pipeline system and the required joint deflection capability of the system.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 25780:2011
Revision Level
1ST EDITION
Status
Current
Publication Date
May 15, 2011
Committee Number
ISO/TC 138/SC 6