ISO-21307 › Plastics pipes and fittings - Butt fusion jointing procedures for polyethylene (PE) piping systems
The following bibliographic material is provided to assist you with your purchasing decision:
Included in this current edition are the following subparts:
FOR 3RD EDITION AMENDMENT 1 SEE - Jan. 1, 2020
ISO 21307:2017 establishes general principles regarding the procedure used in the construction and quality assessment of butt fusion jointing of polyethylene (PE) piping system components specified in accordance with relevant ISO standards. These components are installed in accordance with the relevant codes of practice, national regulations or industry guidance. Specifically, this document specifies three butt fusion jointing procedures for PE pipes and fittings. These are:
- single low-pressure fusion jointing procedure;
- dual low-pressure fusion jointing procedure;
- single high-pressure fusion jointing procedure.
ISO 21307:2017 takes into consideration the materials and components used, the fusion jointing procedure and equipment and the quality assessment of the completed joint. It can be applied in conjunction with appropriate national regulations and standards.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 21307:2017
Revision Level
3RD EDITION
Status
Current
Publication Date
Dec. 1, 2017
Committee Number
ISO/TC 138/SC 4