ISO-10332 › Historical Revision Information
Seamless and welded (except submerged arc-welded) steel tubes for pressure purposes - Ultrasonic testing for the verification of hydraulic leak-tightness

ISO-10332 - 1ST EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:


ISO 10332:2010 specifies requirements for automated ultrasonic shear-wave (generated by single element probes or the phased-array technique) testing of seamless and welded (except submerged arc-welded) steel tubes, for verification of hydraulic leak-tightness.

The testing technique is applied for the detection of predominantly longitudinal imperfections.

Where applicable, Lamb-wave testing may be applied at the discretion of the manufacturer.

ISO 10332:2010 is applicable to the inspection of tubes with an outside diameter greater than or equal to 10 mm, and with an outside diameter-to-thickness ratio greater than or equal to 5.

ORDER

To find similar documents by classification:

23.040.10 (Iron and steel pipes Steel pipes and tubes for specific use, see 77.140.75)

77.040.20 (Non-destructive testing of metals Non-destructive testing in general, see 19.100 Non-destructive testing of welded joints, see 25.160.40)

77.140.75 (Steel pipes and tubes for specific use Including hollow steel bars and sections for construction Steel pipes for conducting fluids, see 23.040.10)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ISO 10332:1994

Revision Level

1ST EDITION

Status

Superseded

Publication Date

Feb. 1, 1994

Committee Number

ISO/TC 17/SC 19