IEC-61189-5-301 › Test methods for electrical materials, printed boards and other interconnection structures and assemblies - Part 5-301: General test methods for materials and assemblies - Soldering paste using fine solder particles
IEC-61189-5-301
-
EDITION 1.0
-
CURRENT
Document Center Inc. is an authorized dealer of IEC standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
IEC 61189-5-301:2021 specifies methods for testing the characteristics of soldering paste using fine solder particles (hereinafter referred to as solder paste).
This document is applicable to the solder paste using fine solder particle such as type 6, type 7 specified in IEC 61190-1-2 or finer particle sizes.
This type of solder paste is used for connecting wiring and components in high-density printed circuit boards which are used in electronic or communication equipment and such, equipping fine wiring (e.g., minimum conductor widths and minimum conductor gaps of 60 µm or less).
Test methods for the characteristics of solder paste in this document are considering the effect of surface activation force due to the fine sized solder particles which could affect the test result by existing test methods.
To find similar documents by classification:
31.180 (Printed circuits and boards)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
IEC 61189-5-301 Ed. 1.0 b:2021
Revision Level
EDITION 1.0
Status
Current
Publication Date
March 1, 2021
Committee Number
91