IEC-60745-2-5 › Hand-held motor-operated electric tools - Safety - Part 2-5: Particular requirements for circular saws
Document Center Inc. is an authorized dealer of IEC standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
IEC 60745-2-5:2010 deals with the safety of hand-held motor-operated or magnetically driven electric tools, specific requirements for all types of circular saws. The rated voltage being not more than 250 V for single-phase a.c. or d.c., and 440 V for three-phase a.c. tools. This standard does not apply to saws used with abrasive wheels. The principal changes in this edition as compared with the fourth edition are as follows:
- clause 17 introduction of endurance tests in practical use for the guards of all types of saws;
- clause 19 clarifications and editorial improvements in respect to the guarding;
- annex M editorial improvements.
This publication is to be read in conjunction with IEC 60745-1:2006.
To find similar documents by classification:
25.140.20 (Electric tools Chain- and brush-saws, see 65.060.80)
25.140.30 (Hand-operated tools Including wrenches, screwdrivers, pliers, nippers, hammers, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
IEC 60745-2-5 Ed. 5.0 b:2010
Revision Level
EDITION 5.0
Status
Current
Publication Date
July 1, 2010
Committee Number
116