IEC-60695-2-21 › Fire hazard testing - Part 2-21: Glowing/hot-wire based test methods - Fire containment test on finished units
IEC-60695-2-21
-
EDITION 1.0
-
CURRENT
Document Center Inc. is an authorized dealer of IEC standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
IEC 60695-2-21:2023, which is a Technical Specification, specifies a fire containment test method for finished units. It is intended to verify the capability of containing of a fire event generated by an effective ignition source inside a finished unit.
Unless otherwise specified by the relevant product standard, determination of the fire containment described in this document does not apply to any of the following:
- A single electrical component;
- A single electrical component when incorporated into a finished unit;
- Electrical installation products such as distribution boards, circuit protection devices, switchgear, controlgear, cable management system and electrical accessories (wiring devices).
To find similar documents by classification:
13.220.40 (Ignitability and burning behaviour of materials and products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
IEC/TS 60695-2-21 Ed. 1.0 en:2023
Revision Level
EDITION 1.0
Status
Current
Publication Date
June 1, 2023
Committee Number
89