ASTM-F991M › Standard Specification for Docking/Drain Plug and Boss Assemblies [Metric] (Withdrawn 2013)
The following bibliographic material is provided to assist you with your purchasing decision:
This specification provides design, construction, and purchasing criteria for docking/drain plug and boss assemblies. Assemblies are intended for installation in shell, rudder, and tank bottom plate. Assemblies shall be installed at the lowest point of a tank or rudder for draining during dry docking. Docking plugs and bosses shall be classified as follows: type I - docking plug and bosses for plating from 8 to 15 mm, and type II - docking plug and bosses for plating greater than 15 to 38 mm. The procedure for installing docking/drain plug and boss assemblies are presented.
Scope
1.1 This specification provides design, construction, and purchasing criteria for docking/drain plug and boss assemblies.
1.2 Assemblies are intended for installation in shell, rudder, and tank bottom plate from 8 through 38 mm.
1.3 Assemblies shall be installed at the lowest point of a tank or rudder for draining during dry docking.
1.4 The values stated in SI units are to be regarded as the standard.
Keywords
boss assemblies; docking/drain plug; drydocking; rudder; shell; tank bottom plate ; ICS Number Code 23.020.10 (Stationary containers and tanks)
To find similar documents by ASTM Volume:
01.07 (Ships and Marine Technology)
To find similar documents by classification:
23.020.10 (Stationary containers and tanks)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F991M-12
Revision Level
2012 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Nov. 15, 2012
Document Type
Specification
Page Count
3 pages
Committee Number
F25.01