Document Center is acquired by Nimonik

Scope

1.1 This specification covers thermoplastic elastomeric seals (gaskets) used to seal the joints of plastic pipe and fittings used for gravity and low-pressure applications. This specification refers to push-on joints that require no internal or external pressure to effect the initial seal.

1.2 Requirements are given for thermoplastic elastomers.

1.3 The following precautionary caveat pertains only to the test methods portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

elastomeric; joining; piping; seals; thermoplastic; ICS Number Code 23.040.80 (Seals for pipe and hose assemblies)

To find similar documents by ASTM Volume:

08.04 (Plastic Piping Systems)

To find similar documents by classification:

23.040.80 (Seals for pipe and hose assemblies)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.