Document Center is acquired by Nimonik

Scope

1.1 This specification covers the chemical and mechanical requirements for stainless steel inch hexagon socket button (SBHCS) and flat countersunk (SFHCS) head cap screws with nominal thread 0.060 through 0.625 in. intended for use in applications requiring general corrosion resistance.

1.2 The following two conditions are covered:

1.2.1 Austenitic alloy condition AF in an annealed condition at 85 ksi maximum and

1.2.2 Austenitic alloy condition CW in a cold-worked condition at 95 ksi minimum.

1.3 The following precautionary caveat pertains only to the test method portion, Section 12, of this specification: This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

countersunk head cap screws; head cap screws; screws; stainless steel-screws; steel bolting materials-screws; head cap screws (socket button/flat countersunk)-stainless steel; ICS Number Code 21.060.10 (Bolts, screws, studs)

To find similar documents by ASTM Volume:

01.08 (Fasteners; Rolling Element Bearings)

To find similar documents by classification:

21.060.10 (Bolts, screws, studs)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.