ASTM-F824 › Standard Specification for Tables, Mess, Marine, Steel
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers the construction of round, square, and rectangular marine mess tables with or without adjustable lee rails for use in crew, officer, and passenger dining areas aboard ship. These tables are classified into three types. Type I shall be a round mess table with a single pedestal, Type II is a square mess table with a single pedestal and Type III is a rectangular mess table. Type III table may be designated according to the number of pedestals it contains: Grade 1 with single pedestal and Grade 2 with two pedestals. These tables can also be designated into two classes: Class 1 has fixed lee rails and Class 2 has adjustable lee rails. Table tops shall be steel construction with a decorative melamine laminate top cover. Other materials or components of the table shall include lee rails, edge binders, pedestals, and support plate. Joining of metal components shall be done by welding or gluing with a structural adhesive. Tops for mess tables shall be capable of supporting a load of a certain kilogram uniformly distributed over an area of determined and placed at any location on the top. Load shall remain on top for a certain minimum time, and there shall be no indication of permanent set after removal of load.
Scope
1.1 This specification covers the construction of round, square, and rectangular marine mess tables with or without adjustable lee rails for use in crew, officer, and passenger dining areas aboard ship.
1.2 The values stated in inch-pound units are to be regarded as the standard. The metric equivalents, given in parentheses, are provided for information only.
Keywords
marine furniture; marine mess tables; mess tables; ship dining areas; ICS Number Code 47.020.70 (Navigation and control equipment)
To find similar documents by ASTM Volume:
01.07 (Ships and Marine Technology)
To find similar documents by classification:
47.020.70 (Navigation and control equipment Radiocommunications equipment, see 33.060)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
MIL-STD-129Military Marking for Shipment and Storage
MS-35829
HINGE, BUTT, CONTINUOUS (PIANO) .075 THICKNESS, .187 and .250 PIN DIA (SUPERSEDED BY A-A-55594)
ASTM-A525
Standard Specification for General Requirements for Steel Sheet, Zinc-Coated (Galvanized) by the Hot-Dip Process
Document Number
ASTM-F0824-22
Revision Level
2022 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
April 28, 2022
Document Type
Specification
Page Count
7 pages
Committee Number
F25.03