Document Center is acquired by Nimonik

Scope

1.1 This specification covers requirements and test methods for materials, dimensions, workmanship, flattening resistance, impact resistance, pipe stiffness, extrusion quality, joining systems, and a form of marking for Type PS-46 and Type PS-115 poly(vinyl chloride) (PVC) plastic, gravity flow sewer pipe having a minimum pipe stiffness of 46 psi (320 kPa) and 115 psi (790 kPa), respectively, and fittings.

1.2 Pipe and fittings produced to this specification shall be installed in accordance with Practice D2321.

1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information purposes only.

1.4 The following precautionary caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Pipe fittings;emPVC (poly(vinyl chloride)); Poly(vinyl chloride)(PVC) fittings; Poly(vinyl chloride)(PVC) pipe; Sewer pipe (thermoplastic); sewer pipe/fittings;emPVC, type PS-46 for gravity flow sewer; applications; ICS Number Code 23.040.20 (Plastic pipes)

To find similar documents by ASTM Volume:

08.04 (Plastic Piping Systems)

To find similar documents by classification:

23.040.20 (Plastics pipes)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.