ASTM-F2649 Standard Specification for Corrugated High Density Polyethylene (HDPE) Grease Interceptor Tanks

ASTM-F2649 - 2014 R23 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Specification for Corrugated High Density Polyethylene (HDPE) Grease Interceptor Tanks
ORDER

Price:

$61.00        


Want this as a site license?

Scope

1.1 This specification covers material, design, structural performance, and manufacturing practice requirements for monolithic or sectional corrugated polyethylene grease interceptor tanks with volumes equal to or greater than 333 gallons (1,260 liters ).

1.2 The corrugated high density polyethylene (HDPE) grease interceptor tanks are placed between commercial food service (kitchen) drains and sanitary sewer interceptors to minimize the impact of commercial food service effluent containing grease, oils, soap scum and other typical commercial food service wastes on the sanitary sewer system. Typical sources of commercial kitchen effluent are scullery sinks, pot and pan sinks, dishwashers, soup kettles and floor drains where grease containing materials may exist.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This specification covers pipe and fittings for horizontally laid corrugated HDPE grease interceptor tanks as illustrated in Fig. 1.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

corrugated HDPE pipe; grease interceptor tanks; liquid kitchen waste; wastewater pretreatment; Grease interceptor tanks; HDPE (high-density polyethylene); Wastewater testing/treatment--specifications; ICS Number Code 21.260 (Lubrication systems)

To find similar documents by ASTM Volume:

08.04 (Plastic Piping Systems)

To find similar documents by classification:

13.060.99 (Other standards related to water quality)

21.260 (Lubrication systems Lubricants, see 75.100)

23.020.10 (Stationary containers and tanks)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-F2649-14R23

Revision Level

2014 R23 EDITION

Status

Current

Modification Type

New

Publication Date

April 10, 2023

Document Type

Specification

Page Count

4 pages

Committee Number

F17.26