Document Center is acquired by Nimonik

Scope

1.1 This specification covers requirements for rigid or flat seat type, two channeled race surface, thrust roller bearings.

1.2 Intended UseThe bearings covered in this specification are intended for use in slow rotating or oscillating applications where pure thrust loads are applied.

1.3 This specification contains many of the requirements of MS17169, which was originally developed by the Department of Defense and maintained by the Defense Supply Center in Richmond. The following government activity codes may be found in the Department of Defense, Standardization Directory SD-1.

1.4 For design feature purposes, this specification takes precedence over procurement documents referenced herein.

1.5 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

bearing; MS17169; steering pivot; thrust bearing; ICS Number Code 21.100.20 (Rolling bearings)

To find similar documents by ASTM Volume:

01.08 (Fasteners; Rolling Element Bearings)

To find similar documents by classification:

21.100.20 (Rolling bearings)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.