Document Center is acquired by Nimonik

Scope

1.1 This test method covers procedures for determining the luminous color of a backlit membrane switch. As written, it applies to a fully assembled switch. For specific purposes, it can be applied to partially assembled switches, with the understanding that the results pertain only to the partial assembly and will be modified as the further assembly proceeds.

Significance and Use

Illumination of a switch or of certain features of a switch often has a functional purpose and must meet specification to satisfy the functional requirements of the switch.

Illumination of the switch can be affected by variations in the quality and design of the overlay and its application.

This test method addresses only the optical and visual appearance of the switch and not its electrical function.

This test method is non-destructive.

If this test method is applied to the entire switch assembly, the results can be applied to the whole device. However, it may be sufficient and practical to apply the test either to a subassembly only, or to the illumination only, in which case the results apply to that layer only and the net effect on the fully assembled device must be extrapolated.

Keywords

backlit; CIE; color coordinates; colorimeter; diffuse light; electroluminescent material; light emitting diodes; luminance; luminous color; membrane switch; photometer; radiometer; video photometer; ICS Number Code 31.220.20 (Switches)

To find similar documents by ASTM Volume:

10.04 (Electronics; Declarable Substances in Materials; 3D Imaging Systems)

To find similar documents by classification:

31.220.20 (Switches)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.