Document Center is acquired by Nimonik

Scope

1.1 This specification covers requirements for plastic syphonic roof drain systems for industrial, commercial, public, and residential buildings. Requirements for materials, pipe, and fittings are included.

1.2 The interchangeability of pipe and fittings made by different manufacturers is not addressed in this specification. Transition fittings for joining pipe and fittings of different manufacturers is provided for in the referenced pipe and fitting specification.

1.3 In referee decisions, the SI units shall be used for metric-sized pipe and inch-pound units for pipe sized in the IPS system (ANSI B36.10). In all cases, the values given in parentheses are for information only.

1.4 The following safety hazards caveat pertains only to the test methods, Section 7 , of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

DWV; pipe fittings; plastic pipe; polyethylene; siphonic roof drain (building); ICS Number Code 91.060.20 (Roofs)

To find similar documents by ASTM Volume:

08.04 (Plastic Piping Systems)

To find similar documents by classification:

91.060.20 (Roofs Including related elements (gutters, etc.))

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.