ASTM-F1583 › Standard Practice for Communications Procedures—Phonetics
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 Establishment of Phonetics—This practice covers the establishment of phonetics (including an alphabet, numerals, and punctuations), and the procedures for their use, in communications.
1.2 Performance—This practice is intended to facilitate the performance of communications personnel and systems under adverse communications conditions. This objective is achieved by employing easily recognized and used symbols and procedures that are highly resistant to errors. This system may be used with speech, print, or other media.
1.3 Interoperability—This practice is intended to facilitate the interoperability of communications personnel and systems among different organizations, especially if they use different internal practices. This system is also recommended for use within any organization for improved internal communications and uniformity of operations.
1.4 English as Common Language—This practice is intended for use with English. English has been designated by the International Civil Aviation Organization (ICAO) and others as a common interoperability language that is widely used in search and rescue, emergency, and international operations such as aviation, maritime, and military.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
4.1 Communications Errors and Delays—Communications systems, including their procedures and channels, are subject to errors due to noise, interference, weak signals, mistakes, and other causes. They are also subject to delays due to the necessity to detect and correct these errors. There may also be errors and delays due to the lack of trained and experienced operators.
4.2 Error Control—Phonetics enables the control of errors through error detection, and usually prompt correction, for words and characters in speech and printed text. It employs an error correcting system of symbols and procedures that are standardized and easily recognized under adverse or high error communications conditions.
4.3 Symbol Characteristics—The phonetic alphabet is an error detecting and correcting code composed of phonetic symbols that are carefully selected to have distinctive sounds or appearances (or other unique characteristics) that improve detection under adverse conditions (such as severe noise or high errors) and enhance differentiation from each other.
4.3.1 Phonetics are inherently language-dependent. For English text letters, there are 26 phonetic alphabet symbols, that correspond to the 26 letters (from A to Z) that may be used to compose the words in a message. Additional symbols are used for numerals and punctuations.
4.3.2 Phonetic symbols (including an alphabet, numerals, and punctuation) must have unique characteristics as mentioned above, and they should not be restricted to only one communications media.
4.4 Procedures for Error Detection and Correction:
4.4.1 Phonetic communications procedures are used to minimize or eliminate information errors and to facilitate the correct transmission of messages using trained operators.
4.4.2 The phonetic procedures are carefully structured to enable symbol differentiation and error detection based on simple examination of the received data. Using forward error correction (FEC), in most cases the symbols can be identified, and the errors can be corrected promptly with no additional information.
4.4.3 FEC is based on the error detection system, which is usually the more robust of the two. Essentially, in certain poor conditions, it is possible to detect errors even though they may not be correctable (at the moment).
4.5 Procedures for Retransmission—In most cases, prompt error detection and correction is achievable through FEC. If this is not possible or acceptable, manual or automatic repeat-request (ARQ) is employed. The process of error detection can be used to initiate the ARQ and therefore the retransmission of the information, such as an additional copy (or copies). The copy(ies) may be received error free or with correctable errors (especially when compared with previous copy(ies)).
4.6 Use of Non-standard Systems—This phonetic system is not intended to prohibit the use of non-standard brevity or error control systems that are used only internally within any single organization. It also does not preclude the use of additional methods for clarity.
4.7 Use of Standard Systems—This phonetic system is intended to be directly interoperable with the majority of standard phonetic systems presently employed, both internationally and within the United States, as noted in references (1-9). These standard systems actually exhibit many variations among themselves. Some provide no procedures, and none include all of the symbols presented herein. Of all these known documents, this practice is the only one that presents an explanation of the phonetic system in terms of modern communications technology. To achieve interoperability and performance through bona fide standardization, system administrators should consider this comprehensive practice for superseding, or revising, these other standard systems.
Keywords
alphabet; communications; English; error correction; error detection; interoperability; messages; numeral; performance; phonetic; procedures; punctuation; symbols;; ICS Number Code 33.020 (Telecommunications in general)
To find similar documents by ASTM Volume:
13.02 (Emergency Medical Services; Search and Rescue; Anesthetic and Respiratory Equipment)
To find similar documents by classification:
33.020 (Telecommunications in general Including infrastructure)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1583-95(2019)
Revision Level
1995 R19 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
April 1, 2019
Document Type
Practice
Page Count
5 pages
Committee Number
F32.02