Document Center is acquired by Nimonik

Scope

1.1 This specification establishes requirements fordimensions and gaging of taper pipe threads used on threaded plastic pipe and fittings.

1.2 Threads meeting this specification shall only be used on those plastic materials deemed suitable by the manufacturer.

1.3 Specialty threads or threads not requiring a leak-tight joint are not covered in this specification. Note 1The terms "wrench makeup" and "wrench tight" are standard terminology for tightness and do not imply using a pipe wrench or other tools which would damage plastic pipe and fittings. The terms "hand-tight" and "hand-tight engagement" refer only to thread gaging (not pipe and fitting connections) and is the definition of the L1 gage length.

1.4 Thread DesignationsThe type of pipe threads included in this specification are designated by specifying in sequence the nominal pipe size, number of threads per inch, and the thread series symbols as follows in accordance with ANSI/ASME B 1.20.1: 3/8-18 NPT. For left-hand threads add LH to the designation, otherwise right-hand threads will be understood. For example: 3/8-18 NPT-LH.

1.4.1 Each of these letters in the symbol has a definite significance as follows:

1.5 The values stated in inch-pound units are to be regarded as the standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see and .

Keywords

fitting threads; pipe threads; plastic pipe threads; taper pipe threads; threads; ICS Number Code 23.040.20 (Plastic pipes)

To find similar documents by ASTM Volume:

08.04 (Plastic Piping Systems)

To find similar documents by classification:

23.040.20 (Plastics pipes)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.