Document Center is acquired by Nimonik

Scope

1.1 This test method covers the thermal response of direct thermal papers to determine uniformity within and between lots. This test method may also be used to test direct thermal products other than paper.

1.2 The Hobart 18VP Thermal Label Printer described in this test method may be used for specification acceptance, product development or research applications, or both, and manufacturing control.

1.3 Although a specific manufacturer has been identified for this equipment, any thermal label printer with equivalent signal output capabilities and sample size requirements would be suitable.

1.4 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses, are for information only.

1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note-Warning-This test method requires making power adjustments and trigger printing while the protective cover is off, thereby exposing the user to electrical hazards.

Keywords

direct thermal paper; dynamic thermal response; dynamic thermal response curve; thermal printer; thermal sensitivity; ICS Number Code 37.100.10 (Reproduction equipment)

To find similar documents by ASTM Volume:

15.09 (Paper; Business Imaging Products)

15.11 (Consumer Products; Light Sport Aircraft; Unmanned Aircraft Systems; Normal and Utility Category Airplane Electrical Wiring Systems; Unmanned Maritime Vehicle Systems (UMVS))

To find similar documents by classification:

37.100.10 (Reproduction equipment Including printing, copying and duplicating machines, bookbinding equipment, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.