ASTM-F1216 Standard Practice for Rehabilitation of Existing Pipelines and Conduits by the Inversion and Curing of a Resin-Impregnated Tube

ASTM-F1216 - 2024A EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Practice for Rehabilitation of Existing Pipelines and Conduits by the Inversion and Curing of a Resin-Impregnated Tube
ORDER

Price:

$63.00        


Want this as a site license?

Scope

1.1 This practice describes the procedures for the reconstruction of pipelines and conduits (4 to 96-in. diameter) by the installation of a resin-impregnated, flexible tube which is inverted into the existing conduit by use of a hydrostatic head or air pressure. The resin is cured by circulating hot water or introducing controlled steam within the tube. When cured, the finished pipe will be continuous and tight-fitting. This reconstruction process can be used in a variety of gravity and pressure applications such as sanitary sewers, storm sewers, process piping, electrical conduits, and ventilation systems.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see 7.4.2.

Keywords

Bypassing; Conduit joining system; Conduits; Curing (in pipeline/conduit rehabilitation); Drainage materials/systems; Drainage systems-drain/waste/vent (DWV); Drainage systems-land drainage; Drainage systems-sewer/drain pipe (thermoplastic); Epoxy resins; Gravity pipe leakage testing; Inspection; Installation-underground; Inversion; Nonpressure piping; Pipe fittings-plastic (general); Pipeline rehabilitation; Plastic pipe/tubing/fittings-reinforced thermosetting resin (RTR); Plastics (reinforced thermosetting); Plastics (thermosetting); Polybutylene (PB) pipe; Polyethylene (PE) conduit; Polyethylene (PE) pipe; Poly(vinyl chloride)(PVC) conduit; Pressure pipelines/piping systems; Rehabilitation; Resin-impregnated tube; Resins; Resins-epoxy; Steel pipe; Styrene; Water supply/distribution systems; rehabilitation of existing pipelines/conduits by inversion and curing of; a resin-impregnated tube, practice; ICS Number Code 23.040.20 (Plastic pipes)

To find similar documents by ASTM Volume:

08.04 (Plastic Piping Systems)

To find similar documents by classification:

23.040.20 (Plastics pipes)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

 

Customers who bought this document also bought:

IEC-60-1
Part 1: General Definitions & Test Requirements, High-Voltage Test Techniques

IEC-555-3
Part 3: Voltage Fluctuations, Disturbances in Supply Systemscaused by Household Appliance

IEC-507
Artificial Pollution Tests on High-Voltage Insulators To Beused on a.C. Systems

Document Number

ASTM-F1216-24A

Revision Level

2024A EDITION

Status

Current

Modification Type

Revision

Publication Date

Nov. 12, 2024

Document Type

Practice

Page Count

8 pages

Committee Number

F17.67