ASTM-F1200 › Historical Revision Information
Standard Specification for Fabricated (Welded) Pipe Line Strainers (Above 150 psig and 150 degrees 6F)
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers welded pipe line strainers for use in applications above 150 psig and 150 F as well as in marine environment conditions. Strainers covered in this specification are classified into simplex, duplex (or multiplex), and automatic (self-cleaning) based on general construction. However, other bases for further classifying strainers are available: pressure ratings and types of port connection, port alignments relative to unit center lines, cover closures, valve types (in duplex), types of baskets or elements, materials of construction, and other design features. Strainers shall be manufactured by casting or forging or fabricated from plates, tubes, or pipes, with inlet and outlet connections requiring welding joined by butt welding. On the other hand, strainers made of carbon or low alloy steel shall be post-weld heat treated. The strainers shall undergo either hydrostatic or air test, while the welds shall be examined visually or radiographically. All tests shall conform to the requirements specified.
Scope
1.1 This specification covers welded strainers in services above 150 psig or 150°F (1 MPa and 65°C). For welded strainers in services at or below these ratings and cast strainers, see Specification F1199.
1.2 This specification provides the minimum requirements for the design fabrication, rating, marking, and testing of welded pipe line strainers for services above 0°F (−18°C).
1.3 Strainers manufactured to this specification are acceptable for use in the marine environment.
1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.5 The following safety hazards caveat pertains only to the test methods portion, Section 8, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
cast strainers; marine strainer; strainer; welded strainers; Automatic self-cleaning strainers; Duplex strainers; Multiplex strainers; Pipeline operations--specifications; Shipbuilding piping materials--specifications; Shipbuilding steel pipe materials--specifications; Simplex strainers; Steel pipe--specifications; Strainers; Welded steel shipbuilding materials; ICS Number Code 23.040.01 (Pipeline components in general. Pipelines)
To find similar documents by ASTM Volume:
01.07 (Ships and Marine Technology)
To find similar documents by classification:
23.040.01 (Pipeline components and pipelines in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1200-88(2010)
Revision Level
1988 R10 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
April 1, 2010
Document Type
Specification
Page Count
4 pages
Committee Number
F25.11