Document Center is acquired by Nimonik

Scope

1.1 This specification provides design and construction criteria for a semi-flush, oiltight and watertight bolted hinged manhole cover assembly.

1.2 The manhole cover assemblies depicted on this specification are for use in decks or bulkheads requiring oiltight and watertight covers that are not required to be completely flush. Manhole cover assemblies shall be complete with covers, mounting rings, gaskets, studs, washers, hinge assemblies, and nuts.

1.3 Handles, if required, shall be as specified in the ordering information.

1.4 Values stated in inch-pound units are to be regarded as standard.

1.5 This standard is not applicable to certain hazardous cargos. (See 46CFR 153.254 and 46CFR 154.340.)

1.6 This specification provides design and construction for manhole cover assemblies subjected to primary or cyclic loads, other reinforcement or construction criteria may be necessary to integrate the manhole assembly with the required structural reinforcement for openings in decks or bulkheads. Design of the manhole cover assembly for primary or cyclic loads is beyond the scope of this specification.

Keywords

Cover assembly; Hinged manhole cover assembly; Manholes; Oiltight manhole cover assembly; Semi-flush manhole cover assembly; Shipbuilding steel materials; Watertight manhole cover assembly; manhole cover assembly (bolted/hinged/semi-flush/oiltight/watertight); ICS Number Code 47.020.10 (Hulls and their structure elements)

To find similar documents by ASTM Volume:

01.07 (Ships and Marine Technology)

To find similar documents by classification:

47.020.10 (Hulls and their structure elements)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.