ASTM-F1067 Test Method for Determining the Performance of a Petroleum Product Filter Cartridge Using a Single-Pass Constant Rate Procedure (Withdrawn 2001)

ASTM-F1067 - 1992 EDITION - CANCELLED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Test Method for Determining the Performance of a Petroleum Product Filter Cartridge Using a Single-Pass Constant Rate Procedure (Withdrawn 2001)

Scope

1.1 This test method covers filter cartridges where the petroleum product feed stream flows at a constant flow rate, makes one pass through the filter cartridge and is not recirculated unfiltered back to the feed tank.

1.2 The flow rate, flow direction, and change out differential pressure for the cartridge will be specified by the manufacturer. These criteria will be included in the performance report.

1.3 The physical properties, including viscosity of the liquid used in the test, should be representative of that found in the end-use application intended for the filter cartridge.

1.4 AC fine test dust will be used as the particle challenge.

1.5 Expressions of filtration performance are in the form of filtration ratios and filtration efficiencies derived from particle-size distributions of test dust acquired by an approved method.

1.6 Filter life is expressed as total mass of challenging contaminant necessary to reach specified change out maximum differential pressure.

1.7 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Contamination-petroleum products; Dust; Filters/filter procedures; Flow and flow rate-filters; Liquids; Particle size analysis; Performance-filters; Petroleum/petroleum products; Pressure testing-petroleum products; Single-pass filter medium; Solid phase materials; Viscosity-petroleum products; performance of petroleum product filter cartridge, using single-pass; constant rate procedure, test; ICS Number Code 71.040.20 (Laboratory ware and related apparatus)

To find similar documents by ASTM Volume:

14.04 (Laboratory Apparatus; Degradation of Materials; SI; Oxygen Fire Safety)

To find similar documents by classification:

71.040.20 (Laboratory ware and related apparatus)

This document comes with our free Notification Service, good for the life of the document.

This document is available in Paper format.

Document Number

ASTM-F1067-92

Revision Level

1992 EDITION

Status

Cancelled

Modification Type

Withdrawn

Publication Date

Jan. 15, 1992

Document Type

Test Method

Page Count

4 pages

Committee Number

S01.