Document Center is acquired by Nimonik

Scope

1.1 This specification covers electrofusion polyethylene fittings for use with outside diameter-controlled polyethylene pipe, covered by Specifications D2447, D2513, D2737, D3035, and F714. Requirements for materials, workmanship, and testing performance are included. Where applicable in this specification "pipe" shall mean "pipe" or "tubing."

1.2 The values stated in inch-pound and centigrade temperature units are to be regarded as standard. The values given in parentheses are for information only.

1.3 The following safety hazards caveat pertains only to the test method portion, Section 9, of this specification: This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

ursting strength; electrofusion type polyethylene fittings for outside diameter-controlled; polyethylene pipe and tubing, spec., ; Crushing strength; electrofusion type polyethylene fittings for outside diameter-controlled; polyethylene pipe and tubing, spec., ; Electrofusion; electrofusion type polyethylene fittings for outside diameter-controlled; polyethylene pipe and tubing, spec., ; Joints-pipe applications; electrofusion type polyethylene fittings for outside diameter-controlled; polyethylene pipe and tubing, spec., ; Pipe fittings-PE (polyethylene); electrofusion type polyethylene fittings for outside diameter-controlled; polyethylene pipe and tubing, spec., ; Plastics (general); electrofusion type polyethylene fittings for outside diameter-controlled; polyethylene pipe and tubing, spec., ; Polyethylene (PE) fittings; electrofusion type polyethylene fittings for outside diameter-controlled; polyethylene pipe and tubing, spec., ; Pressure testing-plastic pipe/tube; electrofusion type polyethylene fittings for outside diameter-controlled; polyethylene pipe and tubing, spec., ; Specimen preparation (for testing)-plastics; electrofusion type polyethylene fittings for outside diameter-controlled; polyethylene pipe and tubing, spec., ; Tension (tensile) properties/tests-plastics; electrofusion type polyethylene fittings for outside diameter-controlled; polyethylene pipe and tubing, spec., ;Order Form; ICS Number Code 23.040.20 (Plastic pipes)

To find similar documents by ASTM Volume:

08.04 (Plastic Piping Systems)

To find similar documents by classification:

23.040.20 (Plastics pipes)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.