ASTM-E2798 Standard Test Method for Characterization of Performance of Pesticide Spray Drift Reduction Adjuvants for Ground Application

ASTM-E2798 - 2019 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Characterization of Performance of Pesticide Spray Drift Reduction Adjuvants for Ground Application
ORDER

Price:

$69.00        


Want this as a site license?

Scope

1.1 This test method is used to characterize the performance of pesticide spray drift reduction adjuvants with respect to spray droplet size spectra, volume of fines, and other use parameters under simulated field ground application conditions. This test method does not include any procedures to evaluate if pump shear degrades the performance of the spray drift reduction adjuvant.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

Note 1: This method uses industry-standard units. The following conversions to SI units are provided for convenience: 1 mph = 1.61 kph; 1 in = 2.54 cm; 1 gal/acre = 9.36 L/hectare.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Significance and Use

5.1 Pesticide regulations for the minimization of drift during pesticide application often require active ingredient (a.i.) product use under defined droplet size conditions. Spray performance with respect to transport and deposition of droplets and particles at target surfaces and product efficacy for desired applications are also affected by droplet size spectra. The effect of drift reduction adjuvants on droplet size spectra should be understood in this context. The present test method describes standard tests that can be conducted to investigate the performance of pesticide spray drift reduction adjuvants under simulated field use conditions for drift management decisions in the context of the entire spraying process. The measured reduction in driftable fines and shift in spray droplet size distribution can be used to reduce the buffer zones mandated by regulatory agencies.

Keywords

adjuvant; aerosol spray drift; drift control; drift reduction; droplet size spectrum; ground application; tank mix;

To find similar documents by ASTM Volume:

11.05 (Pesticides and Alternative Control Agents; Environmental Assessment; Hazardous Substances and Oil Spill Response)

To find similar documents by classification:

65.100.01 (Pesticides and other agrochemicals in general)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-E2798-19

Revision Level

2019 EDITION

Status

Current

Modification Type

Revision

Publication Date

Dec. 15, 2019

Document Type

Test Method

Page Count

6 pages

Committee Number

E35.22