ASTM-E1910 Standard Test Method for Agricultural pH Control Agents, Measurement of pH Change and Buffering Capacity

ASTM-E1910 - 2021 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Agricultural pH Control Agents, Measurement of pH Change and Buffering Capacity
ORDER

Price:

$61.00        


Want this as a site license?

Scope

1.1 These test methods cover determining if an adjuvant meets the definition of an acidifier in Terminology E1519.

1.2 The values stated in both inch-pound and SI units are to be regarded separately as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

This test method is intended for products sold as tank mix adjuvants for use with agricultural products.

Part A provides a determination of whether the pH modification characteristics of the adjuvant tested meet the definition of an acidifier, alkalinity agent, or a basic blend in Terminology E 1519. Part B provides a measure of the buffer capacity of the adjuvant. This can be used to estimate the amount of a buffer that will be required to keep a spray solution at the desired pH.

Other pH standards can be used (see Test Method E 70) as long as the pHs measured are not outside the range of the standards used.

If samples of the material to be used in a particular application are available, the first method can be used to determine what adjuvant rate is required to obtain the desired pH. The ability of an adjuvant to adjust the pH of a particular system will depend on the initial pH before addition.

The second method can be used to determine the amount of an adjuvant required to change the pH of a quantity of spray solution to the required value (see Note 1).

Note 1—Many acidifiers and basic blends also are buffers, so the pH change does not provide a useful measure of buffer capacity.

Keywords

acidifier; adjuvant; agricultural adjuvant; basic blend; pH; ICS Number Code 65.020.99 (Other standards related to farming and forestry)

To find similar documents by ASTM Volume:

11.05 (Pesticides and Alternative Control Agents; Environmental Assessment; Hazardous Substances and Oil Spill Response)

To find similar documents by classification:

65.020.99 (Other standards related to farming and forestry)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-E1910_E1910M-21

Revision Level

2021 EDITION

Status

Current

Modification Type

Revision

Publication Date

May 17, 2021

Document Type

Test Method

Page Count

3 pages

Committee Number

E35.22