ASTM-D926 › Standard Test Method for Rubber Property—Plasticity and Recovery (Parallel Plate Method)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method describes the determination of plasticity and recovery of unvulcanized rubber by means of the parallel plate plastometer. Uncompounded, compounded, and reclaim rubber may be tested.
Note 1-ISO 2007 and D3194 use a principle similar to this test method although the apparatus, test conditions, and procedure are different.1.2 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use .
Keywords
Parallel plate plastometer; plasticity/recovery of unvulcanized rubber, test,; Plasticity and recovery; rubber, by parallel plate plastometer, test,; Plastisols and organosols; parallel plate, in plasticity and recovery test of rubber,; Rubber-general; plasticity and recovery, by parallel plate plastometer, test
To find similar documents by ASTM Volume:
09.01 (Rubber, Natural and Synthetic -- General Test Methods; Carbon Black)
To find similar documents by classification:
83.060 (Rubber Raw rubber, see 83.040.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
IPC/EIA-J-STD-001Requirements for Soldered Electrical and Electronic Assemblies
IPC-A-610
Acceptability of Electronic Assemblies (Hardcopy format)
MIL-STD-883
Microcircuits
Document Number
ASTM-D0926-17R22
Revision Level
2017 R22 EDITION
Status
Current
Modification Type
Revision
Publication Date
Oct. 18, 2022
Document Type
Test Method
Page Count
4 pages
Committee Number
D11.12