ASTM-D866 › Standard Specification for Crosslinked Styrene-Butadiene (SBR) Synthetic Rubber Jacket for Wire and Cable (Withdrawn 2009)
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers a crosslinked styrenebutadiene (SBR) synthetic rubber compound suitable for use as the outer covering or jacket on insulated electrical wires or cables for heavy-duty service. Physical properties of the synthetic rubber before aging, after aging, and after air oven testing such as tensile strength, tension, and elongation at rupture shall be determined.
Scope
1.1 This specification covers a crosslinked styrene-butadiene (SBR) synthetic rubber compound suitable for use as the outer covering or jacket on insulated electrical wires or cables for heavy-duty service.
1.2 This jacket is not recommended for installation at a temperature lower than 35 °C.
1.3 Whenever two sets of values are presented, in different units, the values in the first set are the standard, while those in parentheses are for information only.
Keywords
crosslinked jacket; rubber jacket; styrene-butadiene jacket; synthetic rubber jacket
To find similar documents by ASTM Volume:
10.01 (Electrical Insulation (I): D69 - D2484)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D866-99(2004)
Revision Level
1999 R04 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Jan. 1, 2004
Document Type
Specification
Page Count
1 page
Committee Number
D09.18