ASTM-D7710 › Standard Test Method for Determination of Volume and Density of Rigid and Irregularly Shaped Molded Cellular Materials (Withdrawn 2021)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method is used to determine the volume and density of irregularly shaped molded products.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.
Note 1: There is no known ISO equivalent to this standard.
Significance and Use
4.1 The test procedure provides a standard method of obtaining data for research and development, quality control, acceptance and rejection under specifications and for special purposes.
4.2 The data obtained by this test method is applicable to the material under the conditions of this particular test and are not necessarily the same as obtained under other environments in use.
Keywords
volume; density; molded; polyurethane; irregularly shaped; cellular materials;
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D7710-14
Revision Level
2014 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Sept. 15, 2014
Document Type
Test Method
Page Count
3 pages
Committee Number
D20.22