ASTM-D7530 › Standard Specification for Self-Adhesive Glass Fiber Fabric Reinforced Polymer Modified Asphalt Steep Slope Roll Roofing Surfaced with Mineral Granules
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers prefabricated, self-adhesive, glass fiber fabric reinforced, polymer-modified asphalt roll roofing, with granule surfacing, designed for steep slope applications. These products use polymer modifiers in their top and bottom coatings and have an adhesive bottom layer which is exposed by removal of a peel-away protective release paper or film sheet. The specified tests and property limits used to characterize the sheet materials are intended to establish minimum, or maximum properties. The minimum physical properties required for the sheet include thickness, peak load, elongation, tear strength, adhesion to plywood, side lap integrity, thermal stability, and granule loss.
Scope
1.1 This specification covers prefabricated, self-adhesive, glass fiber fabric reinforced, polymer-modified asphalt roll roofing, with granule surfacing, designed for steep slope applications. These products use polymer modifiers in their top and bottom coatings. These products have an adhesive bottom layer which is exposed by removal of a peel-away protective release paper or film sheet.
1.2 The specified tests and property limits used to characterize the sheet materials are intended to establish minimum, or maximum properties. In-place roof system design criteria, such as fire resistance, field strength, impact/puncture resistance, material compatibility, uplift resistance, and others, are factors beyond the scope of this material specification. Factors regarding the suitability of specific roof constructions or application techniques are beyond this scope.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
modified asphalt sheet; polymer modified; self-adhesive; steep slope roofing; thermoplastics; Glass-fiber-reinforced (GRG) materials; Polymer-modified asphalts; Roofing asphalt; Roofing materials/applications--specifications; Steep slope roofing applications; ICS Number Code 91.100.50 (Binders. Sealing materials)
To find similar documents by ASTM Volume:
04.04 (Roofing and Waterproofing)
To find similar documents by classification:
91.100.50 (Binders. Sealing materials Including geomembranes, asphalts for buildings, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D7530_D7530M-17R23
Revision Level
2017 R23 EDITION
Status
Current
Modification Type
New
Publication Date
May 3, 2023
Document Type
Specification
Page Count
5 pages
Committee Number
D08.02