Document Center is acquired by Nimonik

1.1 This specification covers requirements for two types and two classes of sheathed crates each of which may have two base styles. The crates are designed for net loads not exceeding 30 000 pounds lb [13 607 kg] and to withstand the most severe overseas shipping and storage conditions.

1.2 The crates described by this specification are intended to protect items from atmospheric elements during shipment and storage. They are designed to withstand the rough handling of logistic operations including stacking and outside storage for a prolonged period.

1.3 Class 1 and 2 crates may be used interchangeably as desired. However, the Class 2 crate should be used when weight is a prime consideration, as the lack of diagonals and thinner plywood sheathing results in a lighter crate.

1.4 Demountable crates, Type II, should be used whenever it is expected that the contained item will require reshipping to another destination.

1.5 Sill bases, Style B, are intended for items that project below their mounting points, such as disassembled vehicles.

1.6 If the use of other construction method or techniques is acceptable and permitted (see 5.10), the resulting packaging systems shall be of equal or better performance than would result from the use of these specified materials and procedures. The appropriate distribution cycle, specified in Practice D4169 can be used to develop comparative procedures and criteria.

1.7 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. See IEEE/ASTM SI 10 for conversion of units.

1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.9 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.