Document Center is acquired by Nimonik

Scope

1.1 This test procedure is based significantly on the GRI GG7 test procedure, Carboxyl End Group Content of Polyethylene Terephthalate (PET) Yarns.

1.2    This test method is used to determine the concentration, in mmol/Kg, of carboxyl end groups (CEG) found in poly(ethylene terephthalate) (PET) yarns by titration.

1.3 This test is applicable to geogrid yarns that are made from PET resin.

Note 1—This test is also applicable to high strength geotextile yarns that are made from PET and are used in reinforcement applications.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

This test method can be used for manufacturing quality control or manufacturing quality assurance purposes to determine the CEG concentration of PET yarns used in either geogrids or geotextiles.

The CEG content of the PET yarns may have an influence on the properties of the geosynthetic, such as its hydrolysis resistance. The lower the value, the higher the hydrolysis resistance of the yarns.

This test does not set the limiting (maximum) value for various engineering applications. Such a specification is a decision of the design engineer, owner, and/or regulator.

Keywords

ICS Number Code 59.080.20 (Yarns)

To find similar documents by ASTM Volume:

04.13 (Geosynthetics)

To find similar documents by classification:

59.080.20 (Yarns Including plied yarns, textured yarns, threads)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.