ASTM-D729 › Standard Specification for Vinylidene Chloride Molding Compounds (Withdrawn 2000)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers thermoplastic molding compounds composed of a copolymer of vinyl chloride and vinylidene chloride in the approximate ratio of 10 to 90, with suitable plasticizers, stabilizers, dyes, and pigments. The molding compounds are suitable for compression, injection, or extrusion molding.
1.2 The values stated in SI units are to be regarded as the standard.
Note 1-The properties included in this specification are those required to identify the types of molding materials covered. There may be other requirements necessary to identify particular characteristics. These will be added to the specification as their inclusion becomes generally desirable and the necessary test data and methods become available. Note 2-There is no similar or equivalent ISO standard.1.3 The following precautionary caveat pertains only to the test method portion, Section 8, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Heating tests-plast; Molding/extrusion compounds/materials; Molding/extrusion compounds/materials-vinyl chloride polymers; Vinyl chloride polymers; Vinylidene chloride plast; Viscosity-plast; vinylidene chloride molding compounds; ICS Number Code 83.140.99 (Other rubber and plastic products)
To find similar documents by ASTM Volume:
08.01 (Plastics (I): D256 - D3159)
To find similar documents by classification:
83.140.99 (Other rubber and plastics products)
To find similar documents by Federal Supply Class Code:
FSC 9330 (Plastics Fabricated Materials)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D729-95
Revision Level
1995 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Dec. 10, 1995
Document Type
Specification
Page Count
3 pages
Committee Number
D20.15