Document Center is acquired by Nimonik

Scope

1.1 This specification covers unsintered, pigmented, extruded films or tapes manufactured from polytetrafluoroethylene, in nominal thicknesses from 0.025 mm (0.001 in.) to 0.51 mm (0.020 in.), that are >97 % virgin PTFE in composition prior to introducing pigments.

1.1.1 The use of recycled PTFE for production of unsintered extruded films or tapes has not been identified at this time. When commercial usable processes and materials are available, this specification will be revised to include recycled materials.

1.2 The values stated in SI units are detailed in IEEE/ASTM SI-10 are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—Although this specification and ISO/DIS 13000-1 (1997) and ISO/DIS 13000-2 (1997) differ in approach or detail, data obtained relating to specific properties, using either are technically equivalent.

Note 2—This specification is intended to be a complement to Specification D 6585, as the materials covered herein vary significantly enough due to their additives to warrant a stand-alone set of requirements.

Keywords

apparent density; elongation; extruded; film; fluorocarbon film; pigmented; PTFE; PTFE tape; tape; tensile; thread seal tape; unsintered; ICS Number Code 83.140.10 (Films and sheets)

To find similar documents by ASTM Volume:

08.03 (Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products)

To find similar documents by classification:

83.140.10 (Films and sheets Including plates)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.